Home 55881
- Next area to take apart is the P3 component side cover of the governor.
- Ready to pull off the lock wire.
- How does this contraption work?
- Top view.
- Made a stand for the governor to make it easier to disassemble.
- Part one, where to start removing parts of the governor.
- Ready to take off the compressor inlet temperature sensor protective cover.
- First few scews taken off!
- Just nine screws holds the cover on.
- Protective metal cap taken off the P3 temperature sensor.
- Looking down at the governor.
- Power lever side.
- P3 temperature sensor assembly.
- Temperature sensor assembly on the bottom left and the drive gear end to fuel pump.
- Fuel pump drive gear end with reduction gears to the governor flyweight assembly.